Corvair Parts Catalog Corvair Turbocharger Parts pg 43

WARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**

ENGINE DISCOUNT !

see Blue pg. MK-2

Exhaust housing shim

Page 44 after #22

Turbo Parts

This section has all the parts related to the stock Turbo system and performance parts. It has been divided into these sections:

Turbo Identiﬁcation

Part Numbers on Compressor Housing 150 is 3840830 OR 3830651 180 is 3856709

Size of Turbo Parts: Measured approximately

across smallest center of blades – NOT the

outermost measurement.

150 impeller: 1 9/16”

150 turbine: 2 1/16”

180 impeller: 1 13/16”

180 turbine: 2 1/4”

A. Turbo Repair Parts

THESE PARTS ARE FOR 1962–66 TURBO (Except as noted) – Also see Rebuild Kits Section “B” as some

of these par ts are included in those kits.

Add a Turbo??? See Page 54

A. Turbo Repair Parts

B. Turbo Rebuild Kits

C. Turbo Rebuild Service

D. Fuel System (lines, etc.)

E. Stock Turbo Carb.

F. Turbo Air Filter, Intake and

Linkage

G. Other Turbo Parts

H. Performance Parts

Exhaust Wrap, Weber Carb./Adaptor

I. Technical Section

Also See These Related Areas:

Exhaust pages 39–42

Engine Parts pages 3–27

Gauges page 28

PICTURE #

1. Exhaust Housings: USED only, see page 353. See shim, page 44 (after #22).

Nuts: Set of 4. Self-locking, hold exhaust housing to base. C3756 2 oz./set

Bolts: Set of 3. 1962–63 exhaust housing outlet. C3161 4 oz./set

Studs: Set of 3. 1964–66 stainless steel & brass nuts for outlet of Turbo exhaust housing. Includes instructions. C999 3 oz./set

2. “V” Clamp: 1962–64 (also great for 1965–66). C684 1 lb.

Nut for Clamp: Discontinued.

3. Exhaust Housing Gasket C382 2 oz.

4. Exhaust Turbine & Shaft: 1962–64, 150 HP C1002 Discontinued USED: CU1002 1 lb.

1965–66, 180 HP C1004 1 lb. USED: CU1004 1 lb.

5. Seal Ring (little “piston ring”) & Plastic Suppressor C6 2 oz.

Plastic Suppressor alone C2316 1 oz.

6. “Heat Shield” USED: Cast style CU1108 1 lb.

7. “Heat Shield Spring” C1109 4 oz. USED: CU1109 4 oz.

8. Set of Housing Bolts C4911 4 oz.

9. Shims (reproduced): Also comes in C5 Kit)

Turbo Hoses: Intake manifold, oil drain & vacuum – See page 50

.008 C6507 1 oz. .011 C6510 1 oz.

Set of One Each Shim (6)

C6513 2 oz./set

.009 C6508 1 oz. .012 C6511 1 oz.

.010 C6509 1 oz. .014 C6512 1 oz.

C382

iWARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**ENGINE DISCOUNT !see Blue pg. MK-2Exhaust housing shimPage 44 after #2243Turbo PartsThis section has all the parts related to the stock Turbo system and performance parts. It has been divided into these sections:Turbo IdentificationPart Numbers on Compressor Housing 150 is 3840830 OR 3830651 180 is 3856709Size of Turbo Parts: Measured approximately across smallest center of blades - NOT the outermost measurement.150 impeller: 1 9/16"150 turbine: 2 1/16"180 impeller: 1 13/16"180 turbine: 2 1/4"A. Turbo Repair PartsTHESE PARTS ARE FOR 1962-66 TURBO (Except as noted) - Also see Rebuild Kits Section "B" as some of these par ts are included in those kits.Add a Turbo??? See Page 54A. Turbo Repair PartsB. Turbo Rebuild KitsC. Turbo Rebuild ServiceD. Fuel System (lines, etc.)E. Stock Turbo Carb.F. Turbo Air Filter, Intake and LinkageG. Other Turbo PartsH. Performance Parts Exhaust Wrap, Weber Carb./Adaptor I. Technical SectionAlso See These Related Areas:Exhaust pages 39-42Engine Parts pages 3-27Gauges page 28PICTURE #1. Exhaust Housings: USED only, see page 353. See shim, page 44 (after #22). Nuts: Set of 4. Self-locking, hold exhaust housing to base. C3756 2 oz./set Bolts: Set of 3. 1962-63 exhaust housing outlet. C3161 4 oz./set Studs: Set of 3. 1964-66 stainless steel & brass nuts for outlet of Turbo exhaust housing. Includes instructions. C999 3 oz./set2. "V" Clamp: 1962-64 (also great for 1965-66). C684 1 lb. Nut for Clamp: Discontinued. 3. Exhaust Housing Gasket C382 2 oz.4. Exhaust Turbine & Shaft: 1962-64, 150 HP C1002 Discontinued USED: CU1002 1 lb. 1965-66, 180 HP C1004 1 lb. USED: CU1004 1 lb.5. Seal Ring (little "piston ring") & Plastic Suppressor C6 2 oz. Plastic Suppressor alone C2316 1 oz.6. "Heat Shield" USED: Cast style CU1108 1 lb.7. "Heat Shield Spring" C1109 4 oz. USED: CU1109 4 oz.8. Set of Housing Bolts C4911 4 oz.9. Shims (reproduced): Also comes in C5 Kit) Turbo Hoses: Intake manifold, oil drain & vacuum - See page 50.008 C6507 1 oz. .011 C6510 1 oz.Set of One Each Shim (6)C6513 2 oz./set.009 C6508 1 oz. .012 C6511 1 oz..010 C6509 1 oz. .014 C6512 1 oz.C382