Home | Order Catalog | Online Catalog | New Items | Contact Us |
|
![]() |
|
![]() |
|
![]() |
![]() |
![]() |
|
![]() |
![]() i WARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov** 157 Steering – Typical: '60-69 CARS PICTURE # – REFER TO PICTURE DIAGRAM PAGE 156. 9. Tie Rod Clamp: 4 needed (order BOLTS separately #6, page 156) Replacement (used in kits) C181A 4 oz. Exact Repro (not included in any kits) C181AX 4 oz. 10. Tie Rod Sleeve: Joins the tie rods. Always replace when doing tie rods. STEEL: C181 1 lb. 11. INNER TIE ROD ENDS Year CLARK Repro 1960-62 C951R 1 lb. 1963-64 C951R 1 lb. 1965-69 left threads C3140 1 lb. Either side. Check yours for looseness. SLOTTED NUT: C726 2 oz. GREASE FITTINGS: See #8, page 156 COTTER PIN: SET of 5 – C726A (A little small for some tie rods). 1 oz./Set SET of 5 – C2199 (A little big for some tie rods). 1 oz./Set STAINLESS COTTER PINS Sold SET OF 5 C3106 1 oz./Set 1961-65 FC (Van) STEERING BUSHINGS – front A-arm NYLON PERFORMANCE BUSHINGS – see pg. 167B Upper Bushing – 2 needed per side C4907 8 oz. ea. Lower Bushing – 2 needed per side C3070 8 oz. ea. SHAFT-A-ARM BOLTS – see page 180 FRONT LOWER INNER A-ARM SHAFT All FC (Vans) either side. Wears where the bushing pivots. C2098H 4 lbs. ea. Steering Box "NUT", Lower Control Rod to Suspension: 2 needed. (2) 7/16"bolt thread in. C12872 6 oz. ea. BUSHING WASHERS – UPPER & LOWER: I.D. a little big for upper. EXACT for lower. (4) needed per side. C4617 4 oz. BOLTS: For ends of front bushings. 1 needed per side (each incl. 2 bolt & 2 lw). UPPER BUSHING BOLT: C4756 2 oz. LOWER BUSHING BOLT: C4757 2 oz. BUMPER: on crossmember below control arm. C4615 6 oz. ea. VAN Ball Joints – page 151 Shocks – pages 137-139 Springs – page 140 PICTURE # 1. OUTER TIE ROD ENDS - Either side Note: Outer 1963-64 Non-GM will NOT work with inner original Chevy (order inner & outer Non-OriginaI). 2. TIE ROD SLEEVE: C181 1 lb. 3. IDLER ARM: 1961-65 – Slightly different from original. Has grease fitting. C1614 5 lbs. NUT: Idler arm to drag link C2144 2 oz. (BOLTS: Below to right) 4. TIE ROD CLAMP: 4 needed C181A 2 oz. ea. BOLT KIT: (bolt, lock washer, nut) “Gr 5”: C2146 2 oz./kit "Gr 8": C2147 2 oz./kit 5. INNER TIE ROD ENDS $$ SAVER TIE ROD ENDS – 61-65 Vans (FC) 1965 Vans used equal length tie rod ends. Sleeves were same as on 61-64 Vans. Used as a pair, can be used on one side or both sides of the 61-64 Vans. PAIR (1) left & (1) right TIE ROD ENDS: C10772 (1) PAIR 4 lbs. Same as C10772 BUT ADDS (2) clamps, (2) "Gr 8" bolt kits to the (2) TIE ROD ENDS: C10773 4 lbs. 12 oz. FULL SET-UP FOR 1 SIDE: PAIR of left & right tie rod ends, new sleeve, (2) new clamps, (2) "Gr 8" bolt kits. C10774 5 lbs. 12 oz. 6. "RELAY ARM" (Boomerang shaped): USED units are inspected and REBUILT (we replace inner rubber, nylon, stud, cap & reweld). Your USED one only has a core value if it is rebuildable (we include instructions on how to test your old one). Price INCLUDES core value. C1615R 8 lbs. BRACKET FOR ARM: CX4746 3 lbs. BOLTS FOR BRACKET: C4767 6 oz./set 7. SUBSTITUTE STEERING LINK: From steering box pitman steering arm. The original 15" rod is not available. By machining a longer connecting sleeve and finding "exact" replacement ends, we can offer you a complete replacement unit. (2) ends, special sleeve, clamps, bolts. ALSO SEE 7½. C2372 5 lbs. COTTER PINS: Set of 5 C726A 2 oz./Set STAINLESS COTTER PINS: Set of 5 C31O6 2 oz./set 7½. ORIGINAL SHORT END: #7½ in diagram. Must be used with original “tie rod” sleeve. This CANNOT be used with #7 (C2372) above. We cannot supply #8 (long end). 1961-65 ORIGINAL STYLE SHORT END: C7544 2 lbs. 8. USED COMPLETE CONNECTOR ROD (Pitman arm to Boomerang): See USED page 365 9. RUBBER BOOT (SEAL): Steering link ends (fit original or replacement). C13048 2 oz. ea. 1O. NUT: Used at both ends of steering link. Sold each. C2403 2 oz. ea. OUTER TIE RODS Year NON-GM 1961-64 Van (FC) C4593 1 lb. 1965 Van (FC) C4742R 1 lb. Year NON-GM 1961-64 Van (FC) C4744AR 1 lb. 1965 Van (FC) C4743R 1 lb. 4 BOLTS: Attach idler arm to frame Sold as Set C6856 6 oz./set STABILIZER BARS – SEE PAGE 167B 6 oz. – NEW REPRO C1615R MULTI-KITS see Blue pg. MK-12, pg. MK-13 C181A C181AX C8490 C1665A ![]() |
Next![]() |
Search In Corvair Catalog Content
|
CLARKS- MORE THAN PARTS. |
![]() |
What's
New | Clark's History | Corvair
History | Contact Us | Customer
Service | Technical Service
| Change of Address
Order Catalog | Catalog Indexes | Technical Tips | Corvair Power | Engine Worksheet | Interior Worksheet | Parts We Buy | Cars, Buy or Sell Order Forms: Parts | Gift Certificates | Ordering Policies | Shipping Charges |
![]() |
![]() 400 Mohawk Trail Shelburne Falls, MA 01370 USA All rights reserved. Main Office Phone: 413.625.9776 Fax: 413.625.8498 |