i
WARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**
103
Heater Hoses '61-69 Cars & Vans
PICTURE # – Refer to picture diagram on page 101.
6. Defroster Hose: Original Style.
1961-64 Cars: From floor (rocker panel) to dash. Either side.
Original Style C3425 1 lb.
Rubber Style C3130R 1 lb.
1961-65 Vans: For under the dash.
Almost Identical to original. Either side. C3030 1 lb.
Rubber Style C3030R 1 lb.
'65-69 Defroster Deflectors
Exact replacement. Staple to plastic defroster ducts to direct air onto the windshield.
Complete set of 2, ready to replace those torn warped ones. C3410 6 oz./set
Foam for "Flap": All 1965-69. Under dash in "valve". C3150 1 oz.
Heater Hardware & Foam Seals: 1961-64 Cars
Complete set of hardware = C11699, C11700, C11701, C11702, C11703, C5567 (original size
heater motor screws) & 2 oversize heater motor screws: C11704 10 oz.
A. Cross connector to body nuts: Set of 2 C11699 2 oz.
B. "Speednut/J-nut": "C" screw threads into this nut. C11701 1 oz.
C. Cross connector to blower housing screw & FW C11700 2 oz.
D. Blower housing to body nuts/washers: Set of 2 nuts & 2 washers. C11702 2 oz.
E. Cross connector to body bracket bolts: Set of 4 C11703 4 oz.
F. Heater Blower to "Cross" Box Foam Seal C8149 4 oz.
G. Heater "Cross" Box to Body Foam Seal C8150 4 oz.
H. See page 104
I. See below
Heater Fan Motors
Replace that slow or burned out motor – See screws below.
Hi-Volume Motor: 25% more RPM than stock motor. Fits all 1961-69 (exc. gas heater).
No modification needed. Fits like stock. C3928 6 lbs.
Fan: Replace that rattling or separated fan with this metal one. Exact replacement. C2778 1 lb.
Heater Motor Screws
These little screws hold the heater motor in. The heads are usually rusted off. Sold as a full set.
1961-69 Original Size C5567 2 oz./set
1961-69 Oversize: For stripped or rusted holes C5568 2 oz./set
Screws for 1965-69 Heater Housing: About 18 of these are used to screw the 2 halves together.
Sold in sets of 10. C2124A 2 oz./set
Heater Resistor: 1961-69 – May vary from the original. C2687 4 oz.
Gas Heater Motor: All gas heaters. This is the motor that fits on the end of the burner unit. C6762 5 lbs.
[
Gas Heater Parts – See page 105
Steel Heater Duct Ends
1965-69
Now you can replace those rusted ends
on the ends of the plastic heater ducts.
Excellent repros. Get all your heat!
1. Bottom of end of defroster duct.
C9290 6 oz.
2. Front end of long heater duct.
C9291 6 oz.
3. Rear end of long heater duct - oval
C9291R 8 oz.
MULTI-KITS
see Blue pg. MK-8
C3928
C2778
REPRO
C9291 C9290
C9291R