i
WARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**
93
DOME LIGHT PARTS
Chrome Plastic Dome Light Reflector BASE: 1960-69 Monza C88R 4 oz.
Unplated Dome Light Base: Paint for Corvairs that didn't use plated ones. C9353 6 oz.
Dome Light CONNECTORS: These clips will exactly replace the 2 corroded ones in your dome light.
Just pry them out and cut off the wire. C9067 1 oz .
Dome Light LENS: 1960-69. You won't believe how yellowed your old one is until you see a new one.
1960-69 Cars C456 2 oz.
1961-65 Vans C1266 1 oz.
FC (Van) Dome Light Kits – Fit ALL 95's, Rampsides & Greenbriers
Each KIT includes plastic base, lens, bulb holders & 20" of wire and a bulb.
Kit With White Base C11181 1 lb.
Kit With Chrome Base C11182 1 lb.
GLOVE BOX LIGHT: Bulb C604 2 oz.
GLOVEBOX LIGHT KIT: Use these to replace your original unit or to ADD to 500 's or 700's
that never had one. Comes with enough wire and connections to go back to the fuse panel (or splice into your harness). Includes wire connectors,
glovebox light (may vary slightly from original) and bulb. All 1960-69 C9947 6 oz.
Courtesy Light Supports: Plated; May be slightly different from originals. Sold each.
1960-64 Coupe, 4 Door & Wagon: C2550C 2 oz. 1962-64 Convertible: C2550E 2 oz. 1965-69 All: C2550 2 oz.
Side Marker Lights & Parts
Light Units Base, lens and trim. Non-GM are identical. Front or rear will fit either side.
Application GM Non-GM (No "Guide") REPRO
FRON T 196 8 Clear
1969 Amber
C910 6 oz.
C911 6 oz.
C5427 6 oz.
C5428 6 oz.
C910R 6 oz.
C911R 6 oz.
REAR 1968-69 Red C912 6 oz. - - - - - - - - - C912R 6 oz.
Gasket: Side lights to body. Not original but works. C914R 2 oz.
Socket: 1968-69 wires and molded socket for front or rear side markers. Splice to harness. C913 2 oz.
Bulbs – Amber FRONT LIGHTS 1968-69 C908 1 oz. CLEAR – REAR LIGHTS 1968-69 C909 1 oz.
License Plate Lights – 1960
1960 – Original Glass lens CX4437 2 oz.
1960 – License Plate Lens Gaskets
Round Cork Gasket: That goes around the bulb socket and the glass lens seals against it. C9513 1 oz.
Rectangular Rubber Gasket: That seals license light unit to body. C9514 2 oz.
REPRO LICENSE PLATE LIGHT
1961-69 CARS (exc. wagon)
This excellent repro is in stock. It includes the wire with correct terminal and has original
style plating. Replace that ugly, corroded one! Transfer your lens and gasket or order
new ones.
1961-64 Cars C5436 6 oz.
1965-69 Cars C5437 6 oz.
LICENSE PLATE LENS – Excellent repro of the car rear license plate lens.
Fits 1961-69. Old ones are usually cracked and discolored. This is the 1965-69 style with "light
diffusers" inside. The 1961-64 were identical but did not have the "diffusers".
CAR (exc. 1960 or wagon) LENS C455 2 oz.
Gasket C654 2 oz.
License Plate Lens SCREWS: Not exact original replacements. Sold Set of 2 1961-69 C7578 1 oz./set
License Plate Light To Body SCREWS: Sold Set of 2 1961-69 C7581 1 oz. /set
FC & Lakewood License Light Plastic Housing – New exact
Repro (does not say "guide"). Sold each with studs; paint as needed.
Order retainers & wires separately below. 2 needed.
Plastic Housing C872R 8 oz.
Set of 4 Retainers C7304 1 oz.
New Repro Bulb Socket, Boot & Wires to replace your corroded ones.
New rubber helps seal bulb. Ready to install. C1265 4 oz.
Replacement Bulb C608 2 oz.
FAN BELTS – See page 14
Exact Repro
NOTE: These are exact repros EXCEPT you must
transfer your original trim (around lens) and the
2 studs. You get the lens attached to the white
housing.
C9514
C456
C88R
C1265