Clark's Corvair Parts, Inc. - Corvair Parts Catalog - Over 12,000 parts

WARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**

C50RM

106

Cable Guides

These are the plastic parts that attach under the cover below the dash to guide

the various cables and harness. "Always" broken!

'60-64 Cars

C6801 4 oz.

Screws for Guide: Set of 2

C6843 2 oz./set

'65-69 Cars

C6800 4 oz.

Screws for Guide: Set of 2

C6844 2 oz./set

SCREWS – FRONT CABLE COVER: For cover that goes up slope to right of accelerator pedal inside car.

1960-64 Cars (Set of 7) ORIGINAL SIZE C5430 2 oz./set

For Stripped Holes: OVERSIZE C5431 2 oz./set

1965-69 Cars (Set of 7) ORIGINAL SIZE C5432 2 oz./set

For Stripped Holes: OVERSIZE C5433 2 oz./set

TUNNEL "belly" PAN: Sold Sets of 10. Look original installed (2 Sets usually needed).

Set of 10 1960-64 Cars Original Size C3599 4 oz./set Set of 20 1965-69 Cars Original Size C3104 8 oz./set

1960-64 Cars Oversize C2125 4 oz./set 1965-69 Cars Oversize C3105 8 oz./set

Set of 10 1965-69 Cars Original Size C2176 4 oz./set

1965-69 Cars Oversize C2177 4 oz./set

TOE PANEL COVER SEALS

This dense foam seal glues to the cover (over the cables beside the accelerator pedal). It helps to prevent vibrations

and keeps the cold air from coming into the car from the lower tunnel pan area.

1960-64 Cars C7367 4 oz.

1965-69 Cars C8405 6 oz.

Glue: Any good water resistant glue will do. I suggest our C4870R or C6040 – page 213.

FC CABLE COVER PANEL SCREWS: Hold FC panel on the ﬂoor that covers all of the cables

coming through the ﬂoor. Set of 4 original size C1438P 2 oz.

Set of 4 oversize C1438PX 2 oz.

Thermostat (Bellows) 1961-69 ALL (exc. as noted)

PICTURE #

1. Nut: End of thermostat C4704 2 oz.

THERMOSTAT: Excellent repro. 1961-69 either side. C50RM 6 oz.

3. Rod: Either side 1961-64 (13" long) C207A 4 oz. 1965-69 (8" long) C207 4 oz.

4. Thermostat Rod Clips 1961-69 Left Side C3787 1 oz. Right Side C3788 1 oz.

5. Swivel 1961-64 C208A 2 oz. 1965-69 C208B 2 oz.

6. NYLON BUSHINGS: Pivot pin usually missing or broken. (2) needed per side. 1961-69 All C648 1 oz.

7. "Pin": Pivot for rear heat door 1961-69 C3243 4 oz.

8. Lower Shroud: Thermostat shroud – 1961-69 SEE USED page 349 & "NOS" on website

9. Clip – 1960 : Thermostat rod to thermostat; Plated. C9851 1 oz.

1960 THERMOSTAT

8½. 1960: Much larger (only used 1) CX837 8 oz.

9. Clip – 1960 : Thermostat rods to thermostat; Plated. C9851 1 oz.

Bolts & Washers – 1960

10. Holds thermostat bracket to engine. (Set of 2) C9852 2 oz./set

11. Holds thermostat to bracket (1) C9853 1 oz.

12. Boot: Fits 1960 thermostat rod through left top side of engine shroud (center hole a little bigger than original). C95 2 oz.

13. Rubber Bumpers: See diagram. Fit under air control ring to keep it from rattling on the fan shroud.

Sold set/2 (1 set needed). Once installed, cut off the "installation tail". C853R 2 oz.

14. Clip: See diagram. Retains rod from thermostat. Sold set /2. C992 1 oz.

Thermostat Shields: 1961-69 – These attach to the thermostat bottom engine

shroud. These are just the shield and do not include the attaching bracket that the rod

goes through.

Left: C8418SL Right: C8418SR 4 oz.

iWARNING: Products on this page can expose you to a chemical, which is known to the St ate of California to cause cancer or reproductive harm. **For more information go to www.P65Warnings.ca.gov**C50RM106Cable GuidesThese are the plastic parts that attach under the cover below the dash to guide the various cables and harness. "Always" broken!'60-64 CarsC6801 4 oz.Screws for Guide: Set of 2C6843 2 oz./set'65-69 CarsC6800 4 oz.Screws for Guide: Set of 2C6844 2 oz./setSCREWS - FRONT CABLE COVER: For cover that goes up slope to right of accelerator pedal inside car. 1960-64 Cars (Set of 7) ORIGINAL SIZE C5430 2 oz./set For Stripped Holes: OVERSIZE C5431 2 oz./set 1965-69 Cars (Set of 7) ORIGINAL SIZE C5432 2 oz./set For Stripped Holes: OVERSIZE C5433 2 oz./setTUNNEL "belly" PAN: Sold Sets of 10. Look original installed (2 Sets usually needed). Set of 10 1960-64 Cars Original Size C3599 4 oz./set Set of 20 1965-69 Cars Original Size C3104 8 oz./set 1960-64 Cars Oversize C2125 4 oz./set 1965-69 Cars Oversize C3105 8 oz./set Set of 10 1965-69 Cars Original Size C2176 4 oz./set 1965-69 Cars Oversize C2177 4 oz./setTOE PANEL COVER SEALSThis dense foam seal glues to the cover (over the cables beside the accelerator pedal). It helps to prevent vibrations and keeps the cold air from coming into the car from the lower tunnel pan area. 1960-64 Cars C7367 4 oz. 1965-69 Cars C8405 6 oz.Glue: Any good water resistant glue will do. I suggest our C4870R or C6040 - page 213.FC CABLE COVER PANEL SCREWS: Hold FC panel on the floor that covers all of the cables coming through the floor. Set of 4 original size C1438P 2 oz. Set of 4 oversize C1438PX 2 oz.Thermostat (Bellows) 1961-69 ALL (exc. as noted)PICTURE #1. Nut: End of thermostat C4704 2 oz.2. THERMOSTAT: Excellent repro. 1961-69 either side. C50RM 6 oz.3. Rod: Either side 1961-64 (13" long) C207A 4 oz. 1965-69 (8" long) C207 4 oz.4. Thermostat Rod Clips 1961-69 Left Side C3787 1 oz. Right Side C3788 1 oz. 5. Swivel 1961-64 C208A 2 oz. 1965-69 C208B 2 oz. 6. NYLON BUSHINGS: Pivot pin usually missing or broken. (2) needed per side. 1961-69 All C648 1 oz. 7. "Pin": Pivot for rear heat door 1961-69 C3243 4 oz. 8. Lower Shroud: Thermostat shroud - 1961-69 SEE USED page 349 & "NOS" on website 9. Clip - 1960 : Thermostat rod to thermostat; Plated. C9851 1 oz.1960 THERMOSTAT8 1/2 . 1960: Much larger (only used 1) CX837 8 oz.9. Clip - 1960 : Thermostat rods to thermostat; Plated. C9851 1 oz.Bolts & Washers - 196010. Holds thermostat bracket to engine. (Set of 2) C9852 2 oz./set11. Holds thermostat to bracket (1) C9853 1 oz.12. Boot: Fits 1960 thermostat rod through left top side of engine shroud (center hole a little bigger than original). C95 2 oz.13. Rubber Bumpers: See diagram. Fit under air control ring to keep it from rattling on the fan shroud. Sold set/2 (1 set needed). Once installed, cut off the "installation tail". C853R 2 oz.14. Clip: See diagram. Retains rod from thermostat. Sold set /2. C992 1 oz.Thermostat Shields: 1961-69 - These attach to the thermostat bottom engine shroud. These are just the shield and do not include the attaching bracket that the rod goes through. Left: C8418SL Right: C8418SR 4 oz.